Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 238

ProSafe Managed Switch no ip routing This command disables the IP Router Admin Mode for the master switch. Format Mode no ip routing Global Config ip address This command configures an IP address on an interface. You can also use this command to configure one or more secondary IP addresses on the interface.The value for is the IP address of the interface. The value for is a 4-digit dotted-decimal number which represents the subnet mask of the interface. The subnet mask must have contiguous ones and be no longer than 30 bits, for example 255.255.255.0. This command adds the label IP address in show ip interface. Format Mode ip address [secondary] Interface Config no ip address This command deletes an IP address from an interface. The value for is the IP address of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The value for is a 4-digit dotted-decimal number which represents the Subnet Mask of the interface. To remove all of the IP addresses (primary and secondary) configured on the interface, enter the command no ip address. Format Mode no ip address [{ [secondary]}] Interface Config ip address dhcp Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire network information, such as the IP address, subnet mask, and default gateway from a network DHCP server. When DHCP is enabled on the interface, the system automatically deletes all manually configured IPv4 addresses on the interface. Default Format Mode disabled ip address dhcp Interface Config Routing Commands 238