Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 394

ProSafe Managed Switch • To enable all the flags, give the command as trapflags all. Default Format Mode disabled trapflags { all | errors {all | authentication-failure | bad-packet | config-error | virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change | neighbor-state-change | virtif-statechange | virtneighbor-state-change} } Router OSPFv3 Config no trapflags(OSPFv3) Use this command to revert to the default reference bandwidth. • To disable the individual flag, enter the group name followed by that particular flag. • To disable all the flags in that group, give the group name followed by all. • To disable all the flags, give the command as trapflags all. Format Mode no trapflags { all | errors {all | authentication-failure | bad-packet | config-error | virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change | neighbor-state-change | virtif-statechange | virtneighbor-state-change} } Router OSPFv3 Config show ipv6 ospf This command displays information relevant to the OSPF router. Format Mode show ipv6 ospf Privileged EXEC IPv6 Commands 394