Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 85

ProSafe Managed Switch default, the mode is "community" mode that each member port can forward traffic to other members in the same group, but not to members in other groups. Format Mode private-group name [] [mode {community|isolated}] Global Config no private-group name This command is used to remove the specified private group. Format Mode private-group name Global Config show private-group This command displays the private groups' information. Format Mode show private-groupname [||port ] Privileged EXEC Term Interface Port VLANID Private Group ID Private Group Name Private Group Definition Valid slot and port number separated by forward slashes. The VLAN ID associated with the port. Total number of private groups is 192. The name string can be up to 24 bytes of non-blank characters The mode can be either "isolated" or "community". GARP Commands This section describes the commands you use to configure Generic Attribute Registration Protocol (GARP) and view GARP status. The commands in this section affect both GARP VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). GARP is a protocol that allows client stations to register with the switch for membership in VLANS (by using GVMP) or multicast groups (by using GVMP). set garp timer join This command sets the GVRP join time for one port (Interface Config mode) or all (Global Config mode) and per GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or Switching Commands 85