Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 521

ProSafe Managed Switch level, but below the urgent severity level, are emailed in a non-urgent manner by collecting them together until the log time expires. You can specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Default Format Mode Disabled; when enabled, log messages at or above severity Warning (4) are emailed logging email [] Global Config no logging email This command disables email alerting. Format Mode no logging email Global Config logging email urgent This command sets the lowest severity level at which log messages are emailed immediately in a single email message. Specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none to indicate that log messages are collected and sent in a batch email at a specified interval. Default Format Mode Alert (1) and emergency (0) messages are sent immediately logging email urgent { | none } Global Config no logging email urgent This command resets the urgent severity level to the default value. Format Mode no logging email urgent Global Config logging email message-type to-addr This command configures the email address to which messages are sent. The message types supported are urgent, non-urgent, and both. For each supported severity level, multiple email addresses can be configured. The to-email-addr variable is a standard email address, for example [email protected]. Format Mode logging email message-type {urgent |non-urgent |both} to-addr Global Config Utility Commands 521