Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 536

ProSafe Managed Switch Source {image1 | image2} image1 image2 {image1 | image2} {image1 | image2} Destination {image1 | image2} image2 image1 unit:///{image1 | image2} unit://*/{image1 | image2} Description Download an image from the remote server to either image. In a stacking environment, the downloaded image is distributed to the stack nodes. Upload either image to the remote server. Copy image1 to image2. Copy image2 to image1. Copy an image from the management node to a given node in a Stack. Use the unit parameter to specify the node to which the image should be copied. Copy an image from the management node to all of the nodes in a Stack. write memory Use this command to save running configuration changes to NVRAM so that the changes you make will persist across a reboot. This command is the same as copy system:running config nvram:startup-config. Format Mode write memory Privileged EXEC Simple Network Time Protocol (SNTP) Commands This section describes the commands you use to automatically configure the system time and date by using SNTP. sntp broadcast client poll-interval This command sets the poll interval for SNTP broadcast clients in seconds as a power of two where can be a value from 6 to 10. Default Format Mode 6 sntp broadcast client poll-interval Global Config no sntp broadcast client poll-interval This command resets the poll interval for SNTP broadcast client back to the default value. Format Mode no sntp broadcast client poll-interval Global Config Utility Commands 536