Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 240

ProSafe Managed Switch show dhcp lease Use this command to display a list of IPv4 addresses currently leased from a DHCP server on a specific in-band interface or all in-band interfaces. This command does not apply to service or network ports. Format Mode show dhcp lease [interface ] Privileged EXEC Term Definition IP address, Subnet mask The IP address and network mask leased from the DHCP server. DHCP Lease server The IPv4 address of the DHCP server that leased the address. State State of the DHCPv4 Client on this interface. DHCP transaction The transaction ID of the DHCPv4 Client. ID Lease The time (in seconds) that the IP address was leased by the server. Renewal The time (in seconds) when the next DHCP renew Request is sent by DHCPv4 Client to renew the leased IP address. Rebind The time (in seconds) when the DHCP Rebind process starts. Retry count Number of times the DHCPv4 client sends a DHCP REQUEST message before the server responds. ip route This command configures a static route. The parameter is a valid IP address, and is a valid subnet mask. The parameter is a valid IP address of the next hop router. Specifying Null0 as nexthop parameter adds a static reject route. The optional parameter is an integer (value from 1 to 255) that allows you to specify the preference value (sometimes called "administrative distance") of an individual static route. Among routes to the same destination, the route with the lowest preference value is the route entered into the forwarding database. By specifying the preference of a static route, you control whether a static route is more or less preferred than routes from dynamic routing protocols. The preference also controls whether a static route is more or less preferred than other static routes to the same destination. A route with a preference of 255 cannot be used to forward traffic. For the static routes to be visible, you must perform the following steps: • Enable ip routing globally. • Enable ip routing for the interface. Routing Commands 240