Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 615

ProSafe Managed Switch no username snmpv3 authentication Use this command to set the authentication protocol to be used for the specified user to none. The is the user name for which the specified authentication protocol is used. Format Mode no username snmpv3 authentication Global Config username snmpv3 encryption Use this command to specify the encryption protocol used for the specified user. The valid encryption protocols are des or none. If you select des, you can specify the required key on the command line. The encryption key must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the user is prompted for the key. When you use the des protocol, the login password is also used as the snmpv3 encryption password, so it must be a minimum of eight characters. If you select none, you do not need to provide a key. The value is the login user name associated with the specified encryption. You must enter the in the same case you used when you added the user. To see the case of the , enter the show users command. Default Format Mode no encryption username snmpv3 encryption {none | des[key]} Global Config no username snmpv3 encryption Use this command to set the encryption protocol to none. The is the login user name for which the specified encryption protocol will be used. Format Mode no username snmpv3 encryption Global Config show users Use this command to display the configured user names and their settings. This command is only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed if SNMP is available on the system. Format Mode show users Privileged EXEC Management Commands 615