HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Configur - Page 104
Smart Link configuration examples, Single smart link group configuration example, Network requirements
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Task Clear the statistics about flush messages. Command reset smart-link statistics Remarks Available in user view Smart Link configuration examples Single smart link group configuration example Network requirements As shown in Figure 23, Device C and Device D are smart link devices, and Device A, Device B, and Device E are associated devices. Traffic of VLANs 1 through 30 on Device C and Device D are dually uplinked to Device A. Configure Smart Link on Device C and Device D for dual uplink backup. Figure 23 Network diagram Configuration procedure 1. Configure Device C: # Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region configuration. system-view [DeviceC] vlan 1 to 30 [DeviceC] stp region-configuration [DeviceC-mst-region] instance 1 vlan 1 to 30 [DeviceC-mst-region] active region-configuration [DeviceC-mst-region] quit # Shut down GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2, disable the spanning tree feature on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 separately, configure them as trunk ports, and assign them to VLANs 1 through 30. [DeviceC] interface gigabitethernet 1/0/1 [DeviceC-GigabitEthernet1/0/1] shutdown 97