HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Configur - Page 47
Configuration procedure, Network diagram
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Figure 9 Network diagram Correct fiber connection Device A GE1/1/3 GE1/1/4 Cross-connected fibers Device A GE1/1/3 GE1/1/4 GE1/1/3 GE1/1/4 GE1/1/3 GE1/1/4 Device B Ethernet optical port Tx end Rx end Device B Fiber link Configuration procedure 1. Configure Device A: # Enable DLDP globally. system-view [DeviceA] dldp enable # Configure GigabitEthernet 1/1/3 to operate in full duplex mode and at 1000 Mbps, and enable DLDP on the port. [DeviceA] interface gigabitethernet 1/1/3 [DeviceA-GigabitEthernet1/1/3] duplex full [DeviceA-GigabitEthernet1/1/3] speed 1000 [DeviceA-GigabitEthernet1/1/3] dldp enable [DeviceA-GigabitEthernet1/1/3] quit # Configure GigabitEthernet 1/1/4 to operate in full duplex mode and at 1000 Mbps, and enable DLDP on the port. [DeviceA] interface gigabitethernet 1/1/4 [DeviceA-GigabitEthernet1/1/4] duplex full [DeviceA-GigabitEthernet1/1/4] speed 1000 [DeviceA-GigabitEthernet1/1/4] dldp enable [DeviceA-GigabitEthernet1/1/4] quit # Set the DLDP mode to enhanced. [DeviceA] dldp work-mode enhance # Set the port shutdown mode to auto. [DeviceA] dldp unidirectional-shutdown auto 2. Configure Device B: 40