HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Configur - Page 88
Configuration procedure, GigabitEthernet 1/0/2, disable the spanning tree feature
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Figure 21 Network diagram Configuration procedure 1. Configure Device A: # Create VLANs 1 and 2, map VLAN 1 to MSTI 1 and VLAN 2 to MSTI 2, and activate MST region configuration. system-view [DeviceA] vlan 1 to 2 [DeviceA] stp region-configuration [DeviceA-mst-region] instance 1 vlan 1 [DeviceA-mst-region] instance 2 vlan 2 [DeviceA-mst-region] active region-configuration [DeviceA-mst-region] quit # Cancel the physical state change suppression interval setting on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2, disable the spanning tree feature, and set the trusted packet priority type to 802.1p priority. Configure the two ports as trunk ports, and assign them to VLAN 1 and VLAN 2. [DeviceA] interface gigabitethernet 1/0/1 [DeviceA-GigabitEthernet1/0/1] undo link-delay [DeviceA-GigabitEthernet1/0/1] undo stp enable [DeviceA-GigabitEthernet1/0/1] qos trust dot1p [DeviceA-GigabitEthernet1/0/1] port link-type trunk [DeviceA-GigabitEthernet1/0/1] port trunk permit vlan 1 2 [DeviceA-GigabitEthernet1/0/1] quit [DeviceA] interface gigabitethernet 1/0/2 [DeviceA-GigabitEthernet1/0/2] undo link-delay [DeviceA-GigabitEthernet1/0/2] undo stp enable [DeviceA-GigabitEthernet1/0/2] qos trust dot1p [DeviceA-GigabitEthernet1/0/2] port link-type trunk [DeviceA-GigabitEthernet1/0/2] port trunk permit vlan 1 2 81