HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Configur - Page 162
Network diagram
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Figure 41 Network diagram Configuration procedure 1. Configure Switch A: # Configure VLAN 2. system-view [SwitchA] ipv6 [SwitchA] vlan 2 [SwitchA-vlan2] port gigabitethernet 1/0/5 [SwitchA-vlan2] quit [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local [SwitchA-Vlan-interface2] ipv6 address 1::1 64 # Create a VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10 # Set the priority of Switch A in VRRP group 1 to 110, which is higher than that of Switch B (100), so that Switch A can become the master. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 110 # Configure Switch A to operate in preemptive mode so that it can become the master whenever it operates properly, and configure the preemption delay as five seconds to avoid frequent status switchover. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5 # Enable Switch A to send RA messages, so that Host A can learn the default gateway address. [SwitchA-Vlan-interface2] undo ipv6 nd ra halt 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] ipv6 [SwitchB] vlan 2 [SwitchB-vlan2] port gigabitethernet 1/0/5 [SwitchB-vlan2] quit 155