HP 6125G HP 6125G & 6125G/XG Blade Switches High Availability Configur - Page 170
Con VLAN 3., To verify the configuration, use
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
# Create VRRP group 2 and set its virtual IPv6 addresses to FE90::10 and 2::10. [SwitchA-Vlan-interface3] vrrp ipv6 vrid 2 virtual-ip fe90::10 link-local [SwitchA-Vlan-interface3] vrrp ipv6 vrid 2 virtual-ip 2::10 # Enable Switch A to send RA messages, so that hosts in VLAN 3 can learn the default gateway address. [SwitchA-Vlan-interface2] undo ipv6 nd ra halt 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] ipv6 [SwitchB-vlan2] port gigabitethernet 1/0/5 [SwitchB-vlan2] quit [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local [SwitchB-Vlan-interface2] ipv6 address 1::2 64 # Create VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10. [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10 [SwitchB-Vlan-interface2] quit # Enable Switch B to send RA messages, so that hosts in VLAN 2 can learn the default gateway address. [SwitchB-Vlan-interface2] undo ipv6 nd ra halt [SwitchB-Vlan-interface2] quit # Configure VLAN 3. [SwitchB] vlan 3 [SwitchB-vlan3] port gigabitethernet 1/0/6 [SwitchB-vlan3] quit [SwitchB] interface vlan-interface 3 [SwitchB-Vlan-interface3] ipv6 address fe90::2 link-local [SwitchB-Vlan-interface3] ipv6 address 2::2 64 # Create VRRP group 2 and set its virtual IPv6 addresses to FE90::10 and 2::10. [SwitchB-Vlan-interface3] vrrp ipv6 vrid 2 virtual-ip fe90::10 link-local [SwitchB-Vlan-interface3] vrrp ipv6 vrid 2 virtual-ip 2::10 # Set the priority of Switch B in VRRP group 2 to 110, which is higher than that of Switch A (100), so that Switch B can become the master in VRRP group 2. [SwitchB-Vlan-interface3] vrrp ipv6 vrid 2 priority 110 # Enable Switch B to send RA messages, so that hosts in VLAN 3 can learn the default gateway address. [SwitchB-Vlan-interface3] undo ipv6 nd ra halt 3. Verify the configuration: To verify the configuration, use the display vrrp ipv6 verbose command. # Display the detailed information about the VRRP group on Switch A. [SwitchA-Vlan-interface3] display vrrp ipv6 verbose IPv6 Standby Information: Run Mode : Standard Run Method : Virtual MAC 163