Dell Powerconnect W-ClearPass Hardware Appliances W-ClearPass Policy Manager 6 - Page 14

Server Port Configuration Before starting the installation, gather the following information that will need, write it in the table below, and keep it for your records: Table 2: Required Information Requirement Description Hostname) Policy Manager server) Management Port IP Address Management Port Subnet Mask Management Port Gateway Data Port IP Address (optional) Data Port IP Address must not be in the same subnet as the Management Port IP Address Data Port Gateway (optional) Data Port Subnet Mask (optional) Primary DNS Secondary DNS NTP Server (optional) Perform the following steps to set up the Policy Manager appliance: 1. Connect and power on Using the null modem cable provided, connect a serial port on the appliance to a terminal, then connect power and switch on. The appliance immediately becomes available for configuration. Use the following parameters for the serial port connection: l Bit Rate: 9600 l Data Bits: 8 l Parity: None l Stop Bits: 1 l Flow Control: None 2. Login Later, you will create a unique appliance/cluster administration password. For now, use the following preconfigured credentials: login: appadmin password: eTIPS123 This starts the Policy Manager Configuration Wizard. 14 Dell Networking W-ClearPass Policy Manager 6.0 | User Guide