HP Z620 HP Remote Graphics Software 5.4.7 - Page 94
Installing RGS on Linux, Installing the Receiver on Linux
View all HP Z620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
When rgadmin is started, it reports the current status of Single Sign-on and Easy Login. To change the status, check the desired radio button. After clicking Apply, Single Sign-on or Easy Login are immediately available on Windows Vista and Windows 7. Figure 3-23 Dialog to enable or disable Single Sign-on and Easy Login (Windows Vista and Windows 7) Installing RGS on Linux This section describes how to: ● Install and uninstall the RGS Receiver on Linux ● Audio requirements for the Linux Receiver ● Install and uninstall the RGS Sender on Linux. NOTE: The RGS Sender uses TCP/IP port 42966. The Linux installer adds an iptables entry to open this port. Installing the Receiver on Linux NOTE: Beginning with RGS 5.1.3, the Linux RGS Receiver is available in both 32-bit and 64-bit versions. To install the RGS Receiver on Linux, perform the following steps: 1. Login as root. 2. Go to the directory where you downloaded RGS, and change to the directory lin32/receiver (32- bit version) or lin64/receiver (64-bit version). 78 Chapter 3 Installing RGS