IBM 6000R Hardware Maintenance Manual - Page 102
Replacing a hot-swap fan, To ensure proper system cooling, do
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Replacing a hot-swap fan The server comes with six hot-swap fans. You do not need to turn off the power to the server to replace a hot-swap fan assembly. Attention: To help ensure proper cooling, replace a fan that has failed within 48 hours. Note: The speed of the fans will increase if: • One fan fails. • Ambient temperature gets too high. The following illustration shows how to replace hot-swap fans. Note: The illustrations in this document might differ slightly from your hardware. Hot-swap fans To replace a hot-swap fan assembly: 1. Remove the top cover (see "Removing the server top cover and bezel" on page 67). Attention: To ensure proper system cooling, do not remove the top cover for more than 30 minutes during this procedure. 2. Lift the fan release handle and lift the fan out of the server. 3. Slide the replacement fan into the server and press the handle down. 4. Replace the top cover (see "Installing the server top cover and bezel" on page 91). 90 Netfinity 6000R Type 8682 Models 1RY, 2RY