IBM 6000R Hardware Maintenance Manual - Page 161
PCI switch card, You may have to tilt the top of the switch card
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
PCI switch card Before you begin: • Read "Safety information" on page 196. • Review the information in "Before you begin" on page 63. 1 Switch card latches 2 Switch card assembly 1. Power-off the server, if it is on. 2. Disconnect the server from the electrical outlet. 3. Remove the top cover (see "Removing the server top cover and bezel" on page 67). 4. Disconnect the switch card cable from the system board. 5. Disengage the switch card: a. Press the switch card latches toward the front and sides of the server. b. Push the latches through the notches. 6. When the switch card latches have been disengaged from the notches, gently pull the switch card free and lift it up and out of the server. Note: You may have to tilt the top of the switch card toward the front of the server when removing it. 7. To replace the switch card, reverse the steps above. FRU information (service only) 149