IBM 6000R Hardware Maintenance Manual - Page 45
The Multiple Link Interface Driver, Link Support Layer LSL.
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Table 3. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller PCNTNWNW-075 The Multiple Link Interface Driver (MLID) cannot be registered with the Link Support Layer (LSL). PCNTNWNW-079 Explanation: An error occurred while the driver was trying to register with the LSL. Action: Check the version of the NetWare or IntraNetWare Operating System. Make sure that this driver is correct for the version of NetWare or IntraNetWare that you are using. Restart the server. The Multiple Link Interface Driver (MLID) did not initialize MSMTx Free Count. PCNTNWNW-086 PCNTNWNW-087 Explanation: The MSMTx Free Count is not initialized correctly. Action: Restart the server. If the problem persists, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. The driver parameter block is too small. Explanation: The driver parameter block is too small. Action: Restart the server. If the problem persists, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. The media parameter block is too small. PCNTNWNW-091 Explanation: The driver media parameter block is too small. Action: Restart the server. If the problem persists, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. The hardware configuration conflicts. Explanation: You tried to load a new frame type for the existing controller. The hardware assumptions made in doing so are incorrect. This error can also occur if you try to specify a mode (such as, redundancy) that conflicts with another specified mode. Action: Make sure that the hardware configuration matches the software settings. Diagnostics 33