IBM 6000R Hardware Maintenance Manual - Page 183
POST error codes, Error, Code/Symptom, FRU/Action, Run Configuration/Setup, Description
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
AC DC Good Good Description LED LED FRU/Action On Off Standby 1. Move jumper on mode or dc J19 to pins 2-3 to problem. bypass power control. If the DC Good LED comes on, press Ctrl+Alt+Delete. Watch the screen for any POST errors. Check the System Error Log for any listed problems. If the system powers up with no errors: a. Diagnostic LED panel 2. Remove the adapters and disconnect the cables and power connectors to all internal and external devices. Power-on the system. If the DC Good LED comes on, replace the adapters and devices one at a time until you isolate the problem. 3. Power Supply 4. Power Backplane 5. System Board On On Power is OK. N/A POST error codes In the following error codes, X can be any number or letter. Error Code/Symptom 062 (Three consecutive boot failures using the default configuration.) FRU/Action 1. Run Configuration/Setup 2. Battery 3. System Board 4. Processor Symptom-to-FRU index 171