IBM 6000R Hardware Maintenance Manual - Page 88
Installing a hot-swap hard disk drive, Pack Ultra160 Hot-Swap Expansion Kit
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
1 Hard disk drive activity light (green) 2 Hard disk drive status light (amber) 3 SCSI hot-swap hard disk drive connector Note: The hard-disk drive activity light and hard-disk drive status light on the backplane match the hard-disk drive activity light and hard-disk drive status light on the front of the server (see "Start the server" on page 8). The following illustration shows the rear connectors on the hot-swap-drive backplane before the repeater card is installed, as viewed from the rear of the server. 1 SCSI cable connector 2 SCSI power cable connector 3 I2C cable connector Note: To install an additional hot-swap drive backplane on the back of the server, see "Installing a Netfinity 3Pack Ultra160 Hot-Swap Expansion Kit" on page 87. Installing a hot-swap hard disk drive The following illustration shows how to install a hot-swap hard disk drive. Note: You do not have to turn off the server to install hot- swap drives in these bays. 76 Netfinity 6000R Type 8682 Models 1RY, 2RY