IBM 6000R Hardware Maintenance Manual - Page 169
No beep symptoms, Diagnostic panel error LEDs, Power Backplane
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Beep/Symptom Repeating Short Beeps One Long and One Short Beep One Long and Two Short Beeps Two Long and Two Short Beeps FRU/Action 1. Keyboard 2. System Board 1. Video adapter (if present) 2. System Board 1. Video adapter (if present) 2. System Board 1. Video adapter No beep symptoms No Beep Symptom No beep and the system operates correctly. No Beeps occur after successfully completing POST (The Power-On Status is disabled.) No ac power (Power supply ac LED is off) No beep and no video System will not power-up (Power supply ac LED is on) FRU/Action 1. Diagnostic LED Panel 1. Run Configuration/Setup, set the Start Options Power-On Status to enable. 2. Diagnostic LED Panel 3. System Board 1. Check the power cord. 2. Power Supply (If two are installed, swap them to determine if one is defective.) 3. Power Backplane 1. See "Undetermined problems" on page 186 1. See"Power supply LED errors" on page 170 Diagnostic panel error LEDs The system error LED is turned on when an error is detected. If the system error LED is on, remove the cover Symptom-to-FRU index 157