IBM 6000R Hardware Maintenance Manual - Page 48
The Protocol Manager Input Output, Control IOCTL failed.
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Table 4. NDIS 2.01 (OS/2) driver messages for the Ethernet controller PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed. PCNTND-11 Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file. Action: Check and correct the configuration. Protocol Manager registration failed. PCNTND-15 Explanation: The NDIS stack is not configured correctly. Action: Check and correct the configuration. Device not found. PCNTND-16 Explanation: The driver cannot find an Ethernet controller in the server. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. PCI scan specified, device not found. PCNTND-21 Explanation: The driver cannot locate the Ethernet controller on the PCI bus. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. The adapter failed the checksum test. PCNTND-23 Explanation: The driver cannot find an Ethernet controller. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. WARNING: PCNET IRQ found = xx Explanation: The interrupt request (IRQ) setting (xx) in the PROTOCOL.INI file does not match the hardware IRQ setting. Action: Remove the IRQ setting from the PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match the IRQ setting shown in the PCI Slot/Device Information selection of the Advanced Setup menu in the Configuration/Setup Utility program. 36 Netfinity 6000R Type 8682 Models 1RY, 2RY