IBM 6000R Hardware Maintenance Manual - Page 46

Table 3. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller PCNTNWNW-126 The group bit in the node address override was cleared. PCNTNWNW-127 Explanation: The IEEE address has a group bit that indicates that an address belongs to a group of stations. This bit is used only as a destination address; it cannot be used as a source address. You tried to enter a source address with this bit set. The driver cleared the group bit of the source address. Action: None necessary, message is for information only. The local bit in the node address override was set. PCNTNWNW-164 PCNTNWNW-165 Explanation: The local bit in the IEEE address format indicates that the addresses are being managed locally. If you use the node address override capabilities of this driver to enter a new address, the local bit must be set. You entered an address without the local bit set. The driver has set the local bit. Action: None necessary, message is for information only. The device was not found. Explanation: The driver cannot find an Ethernet controller in the server. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. The device was not found at IOADDRESS. PCNTNWNW-167 Explanation: The Ethernet controller cannot be found at the I/O address specified. Action: The Ethernet controller does not require a parameter for the I/O address. Remove the I/O address parameter. PCI scan specified, device not found. Explanation: The driver cannot locate the Ethernet controller on the PCI bus. Action: Verify that the Ethernet controller is enabled. If the problem persists, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. 34 Netfinity 6000R Type 8682 Models 1RY, 2RY