IBM 6000R Hardware Maintenance Manual - Page 44

Table 3. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller PCNTNWNW-066 The cable might be disconnected from the adapter. PCNTNWNW-071 Explanation: The cable might be disconnected from the server Ethernet port. Action: Verify that a cable is connected to the Ethernet port. The matching virtual adapter could not be found. PCNTNWNW-072 PCNTNWNW-073 PCNTNWNW-074 Explanation: You tried to load another instance of the driver with a different I/O address. This new adapter could not be found. Action: Verify that you installed an IBM Netfinity 10/100 Fault Tolerant Adapter and make sure that the adapter is seated correctly. If the adapter is seated correctly, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. A resource tag is unavailable. Explanation: The driver tried to allocate some resources that were not available. Action: Add more memory, or free some memory resources in the server. Then, restart the server. Unable to allocate memory Explanation: The driver failed to allocate the memory needed for normal operation. Action: Add more memory, or free some memory resources in the server. Then, restart the server. The hardware interrupt cannot be set. Explanation: An attempt was made to initialize a given hardware interrupt. The attempt was not successful. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 17 to run the diagnostic programs. If you have an Ethernet adapter installed, make sure that the adapter does not share an IRQ with any other device. 32 Netfinity 6000R Type 8682 Models 1RY, 2RY