IBM 6000R Hardware Maintenance Manual - Page 117

LOAD d:\path\PCNTNW SCAN where d and path are the drive and path where the driver is located. This command causes the device driver to locate the primary adapter and switch the Ethernet traffic to it. Ethernet port connector The following table shows the pin-number assignments for the RJ-45 connector. These assignments apply to both 10BASE-T and 100BASE-TX devices. Pin Signal 1 Transmit data+ 2 Transmit data- 3 Receive data+ 4 Not connected Pin Signal 5 Not connected 6 Receive data - 7 Not connected 8 Not connected Table 21. Ethernet RJ-45 connector pin-number assignments. Advanced System Management ports The server has three communication ports dedicated to the Netfinity Advanced System Management processor. One port uses a standard D-shell serial-port connector, connector C. The other two ports, which are used for the ASM Interconnect function, use a dual RJ-45 connector. You can attach a dedicated modem to the D-shell systemmanagement connector on the rear of the server to communicate with the integrated Netfinity Advanced System Management processor. The ASM Interconnect function uses the RJ-45 system-management connectors. This function enables you to connect the Advanced System Management processors of several rack-mounted servers so that they can communicate with each other in half-duplex mode. The following illustration shows the connectors and lights for the Netfinity Advanced System Management Interconnect board. Note: The illustrations in this document might differ slightly from your hardware. Installing options 105