IBM 6000R Hardware Maintenance Manual - Page 87
Hard disk drive component locations, plane
UPC - 087944534341
View all IBM 6000R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
1 CD-ROM drive 2 Diskette drive 3 Hot-swap bays (up to six) 4 Optional hard disk drives 5 Standard hard disk drives 3.5-inch diskette drive CD-ROM drive 3 hot-swap hard disk drives • The server comes with one integrated drive electronics (IDE) CD-ROM drive and one 3.5-inch, 1.44 MB diskette drive. • The CD-ROM drive bay (bottom left front) supports 5.25-inch, half-high, removable-media drives. However, you cannot install additional removable-media drives in the server. • The server supports three standard and three optional 1-inch (26 mm) slim-high, 3.5-inch, hot-swap hard disk drives in the hot-swap bays. The standard hot-swap bays are bays 1 through 3 (from bottom to top). The optional hot-swap bays are bays 4 through 6 (from bottom to top). Bays 1 through 3 are located in the standard hard disk drive cage, to the left of bays 4 through 6 in the optional hard disk drive cage. Note: The server does not support half-high hot-swap drives or internal tape drives. • The hot-swap bays connect to a hot-swap drive back- plane. The backplane is a printed circuit board behind the bays. Hard disk drive component locations The following illustration shows the hot-swap-drive backplane component locations, as viewed from the front of the server. Note: The illustrations in this document might differ slightly from your hardware. Installing options 75