Yamaha QY700 Owner's Manual - Page 105

4. Output Channels • You use these two pages to select the output locations for each track. The SEQ OUT CH. page sets up channel output for the sequence tracks. The PATTERN OUT CH. page sets up the output for the pattern tracks. • You use the TO TG setting to set the track's output channel to the tone generator block. • You use the MIDI OUT-A and MIDI OUT-B settings to assign each track to a MIDI OUT channel. • The QY700 stores separate channel arrangements for each song. The assignments automatically change each time you switch to a different song. 1. At the SONG PLAY screen, press 3 (OutCh). w The Output Channel setup screen appears. 2. Press u or d as necessary to select the track you want to work on. • Note that the sequence-track settings and pattern-track settings are shown on different pages. You can toggle between the pages by pressing 6. 3. Move the cursor to the appropriate channel-setting entry. 4. Change the value using the data dial, n/y, or the numeric keypad. 5. When you have finished making changes, presse to return to the SONG PLAY screen. 1. Track numbers, track name, and keyboard track • Each track is identified by a track number. • The highlighted track number identifies the keyboard track. The keyboard track is internally connected to the QY700 controller section. 0101 1101 Sequence track: Pattern track: 1,...,32 1,...,16 Press u or d until the track number for the desired track is highlighted. • Use 6 as necessary to switch between the sequence- track page and the pattern-track page. • The keyboard track is indicated by highlight. 2. Measure and beat • The measure value sets the start point for song playback. • The measure and beat values increment during playback to indicate the current song location 0101 1101 Measure: 001,...,999 1. Press d [D1] to move the cursor to the measure setting area. 2. Set the measure value using the data dial, n/y, or the numeric keypad. • You can change the measure value while song playback is in progress. Playback will immediately jump to the new location. • There are three ways to change the measure during playback, as follows. • Press d [D1] to move the cursor to the measure display area, and then change the value as described above. • Rotate the shuttle dial, or press r or f. • Press t to return to the top of the song. 104 Chapter 2. SONG MODE