Yamaha QY700 Owner's Manual - Page 293

2. MIDI 2. MIDI control in/out • These settings determine whether the MIDI messages Start, Stop, Continue Start, Song Position/Pointer, and MIDI Clock will be transmitted or received. (MIDI Clock is only transmitted.) • MIDI Control In is the reception setting, and MIDI Control Out is the transmission setting. 0101 1101 MIDI Control In Off, In-A, In-B, In-A,B Off Messages will not be received. In-A, In-B Messages arriving at the MIDI IN-A connector or at the MIDI IN-B connector will be received. In-A,B Message arriving at either the MIDI IN-A or the MIDI IN-B connector will be received. MIDI Control Out Off, Out-A, Out-B, Out-A,B Off Messages will not be transmitted. Out-A, Out-B Messages will be transmitted from either the MIDI OUT-A connector or from the MIDI OUT-B connector. Out-A,B Messages will be transmitted from both the MIDI OUT-A and B connectors. 3. XG parameter out • When parameter values are modified in Voice mode or Effect mode, this setting specifies whether the operation will be transmitted in realtime from the MIDI OUT connectors as MIDI data. • When using the QY700 together with another XG tone generator, this setting allows the external XG tone generator's voice and effect parameters to be controlled from the QY700. 0101 1101 Off, Out-A, Out-B, Out-A,B Off MIDI will not be output. Out-A, Out-B MIDI will be output from the MIDI OUT- A connector or from the MIDI OUT-B con- nector. Out-A,B MIDI will be output from both the MIDI OUT-A and B connectors. 4. MIDI echo back In-A/In-B • Echo Back is a function by which data received at a MIDI IN connector is re-transmitted from a MIDI OUT connector. These parameters are the echo back settings. • MIDI Echo Back In A sets echo back for data received at the MIDI IN-A connector, and MIDI Echo Back In B for data received at the MIDI IN-B connector. • If you wish to use the QY700's MIDI OUT connectors as MIDI THRU connectors, select Thru A, Thru B, or Thru A,B. • When using an external MIDI keyboard and external MIDI tone generator to record on QY700 tracks, select RecMonitor. • When connecting the QY700's MIDI IN and MIDI OUT connectors to an external MIDI device, select Off. 0101 1101 Off, Thru A, Thru B, Thru A,B, RecMonitor Off Echo back will not be performed. Thru A, Thru B, Thru A, B Echo back will be performed respectively from the MIDI OUT-A connector or the OUT-B connector, or from both OUT-A and OUT-B connectors. RecMonitor Echo back will be performed according to the Out Chan- nel MIDI OUT-A and MIDI OUT-B settings of the Key- board Track or the Recording Track. • System exclusive messages of 128 bytes or longer will not be echoed back. 5. MTC start offset • Specify the delay from when MIDI Time Code is received until when the sequencer is started, in hours:minutes: seconds:frames. • When synchronizing with an MTC-compatible MTR etc., use this setting to make the song begin simultaneously. 0101 1101 hours:minutes:seconds:frames Hours 00 - 23 Minutes 00 - 59 Seconds 00 - 59 Frames 00 - 29 292 Chapter 6. UTILITY MODE