Yamaha QY700 Owner's Manual - Page 169

About voice mode About voice mode vVoice Mode 1Mixer 2Tune 3Voice Edit 4Drum Setup 1 Edit 5Drum Setup 2 Edit • Voice mode is the mode in which you can select and edit the voices that are used in a song. • Voice mode does not have a single fixed "top" display which will always appear when you press the MODE key. (The last-selected display will appear.) • In the QY700, the tracks of the sequencer block and the parts of the tone generator block are connected according to the Song mode Out Channel TO TG settings, as shown in the following diagram. Before you make voice settings, check the Song mode Out Channel TO TG settings, and understand the relation between tracks and parts. (→ p.105) • The settings of the part which is connected to the pattern track by the Out Channel TO TG setting will automatically be overwritten whenever the pattern is switched by the Pattern Voice settings (→ p.225). Sequencer tracks Sequencer block Track 1 2 TO TG 1 2 16 16 17 off 18 off 32 off 1 17 2 18 16 32 Tone generator block Part 1 2 16 17 18 32 Pattern tracks • If the Recording Mode (→ p.106) is set either to Realtime Recording or to Punch Recording, you will also be able to record from this mode. • Voice mode has five sub-mode pages, and these are selected using function keys 1 - 5. Pressing 1 (Mixer) accesses the Mixer page. Here you can set voice, pan and volume etc. for each part. (→ p.170) Pressing 2 (Tune) accesses the Tune page. Here you can make transposition and tuning settings for each part. (→ p.174) Pressing 3 (VoicEdit) accesses the Voice Edit page. Here you can make settings to modify the voice. (→ p.176) Pressing 4 (DrS1Edit) accesses the Drum Setup 1 Edit page. Here you can make settings to modify a drum set voice. (→ p.182) This sub-mode can be selected only if Drum Setup 1 is selected as the voice category for the part where the cursor is located. Pressing 5 (DrS2Edit) accesses the Drum Setup 2 Edit page. Here you can make settings to modify a drum set voice. (→ p.182) This submode can be selected only if Drum Setup 2 is selected as the voice category for the part where the cursor is located. 168 Chapter 3. VOICE MODE