D-Link DGS-1510 User Manual - Page 176

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide Parameter LLDP Forward State LLDP Trap State LLDP-MED Trap State Description Select this option to enable or disable LLDP forward state. When the LLDP State is disabled and LLDP Forward Sate is enabled, the received LLDPDU packet will be forwarded. Select this option to enable or disable the LLDP trap state. Select this option to enable or disable the LLDP-MED trap state. Click the Apply button to accept the changes made. The fields that can be configured for LLDP-MED Configuration are described below: Parameter Fast Start Repeat Count Description Enter the LLDP-MED fast start repeat count value. This value must be between 1 and 10. Click the Apply button to accept the changes made. The fields that can be configured for LLDP Configurations are described below: Parameter Message TX Interval Message TX Hold Multiplier Relnit Delay TX Delay Description Enter the interval between consecutive transmissions of LLDP advertisements on each physical interface. The range is from 5 to 32768 seconds. Enter the multiplier on the LLDPDUs transmission interval that used to compute the TTL value of an LLDPDU. This value must be between 2 and 10. Enter the delay value for LLDP initialization on an interface. This value must be between 1 and 10 seconds. Enter the delay value for sending successive LLDPDUs on an interface. The valid values are from 1 to 8192 seconds and should not be greater than one-fourth of the transmission interval timer. Click the Apply button to accept the changes made. 165