D-Link DGS-1510 User Manual - Page 29

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide The fields that can be configured for Error Disable Trap Settings are described below: Parameter Asserted Cleared Notification Rate Description Select this option to enable or disable the notifications when entering into the error disabled state. Select this option to enable or disable the notifications when exiting from the error disabled state. Enter the number of traps per minute. The packets that exceed the rate will be dropped. The value is between 0 and 1000. Click the Apply button to accept the changes made. The fields that can be configured for Error Disable Recovery Settings are described below: Parameter ErrDisable Cause State Interval Description Select the error disable causes here. Options to choose from are All, Port Security, Storm Control, BPDU Attack Protection, Dynamic ARP Inspection, DHCP Snooping, and Loopback Detect. Select this option to enable or disable the auto-recovery for an error port caused by the specified cause. Enter the time between 5 and 86400 seconds to recover the port. Click the Apply button to accept the changes made. Jumbo Frame This window is used to view and configure the Jumbo Frame size and settings. The Switch supports jumbo frames. Jumbo frames are Ethernet frames with more than 1518 bytes of payload. The Switch supports jumbo frames with a maximum frame size of up to 9216 bytes. To view the following window, click System > Port Configuration > Jumbo Frame, as shown below: Figure 3-9 Jumbo Frame Window 18