D-Link DGS-1510 User Manual - Page 228
ACL Configuration Wizard Add Rule for IPv4 ACL UDP Window
![]() |
View all D-Link DGS-1510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide After selecting the UDP option as the Protocol Type, the following section will appear. Figure 8-7 ACL Configuration Wizard (Add Rule for IPv4 ACL) UDP Window The dynamic fields that can be configured are described below: Parameter Source Destination Source Port Description Select and enter the source information here. Options to choose from are: • Any - Any source traffic will be evaluated according to the conditions of this rule. • Host - Enter the source host's IP address here. • IP - The Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are: • Any - Any destination traffic will be evaluated according to the conditions of this rule. • Host - Enter the destination host's IP address here. • IP - The Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the source port value here. Options to choose from are: • = - The specific selected port number will be used. • > - All ports greater than the selected port, will be used. • < - All ports smaller than the selected port, will be used. • ≠ - All ports, excluding the selected port, will be used. 217
![](/manual_guide/products/dlink-dgs1510-user-manual-acdf2fb/228.png)