D-Link DGS-1510 User Manual - Page 208

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide Queue Rate Limiting This window is used to view and configure the queue rate limiting settings. To view the following window, click QoS > Basic Settings > Queue Rate Limiting, as shown below: Figure 7-6 Queue Rate Limiting Window The fields that can be configured are described below: Parameter Unit From Port / To Port Queue ID Rate Limit Description Select the switch unit that will be used for this configuration here. Select the appropriate port range used for the configuration here. Select the queue ID that will be configured here. Options to choose from are 0 to 7. Select and enter the queue rate limit settings here. When the Min Bandwidth option is selected, enter the minimum bandwidth rate limit value in the space provided. This value must be between 64 and 10000000 kbps. Also, enter the maximum bandwidth (Max Bandwidth) rate limit in the space provided. This value must be between 64 and 10000000 kbps. The granularity is 64. When the minimal bandwidth is configured, the packet transmitted from the queue can be guaranteed. When the maximum bandwidth is configured, packets transmitted from the queue cannot exceed the maximum bandwidth even if the bandwidth is available. When configuring the minimal bandwidth, the aggregate of the configured minimum bandwidth must be less than 75 percent of the interface bandwidth to make sure the configured minimal bandwidth can be guaranteed. It is not necessary to set the minimum guaranteed bandwidth for the highest strict priority queue. This is because the traffic in this queue will be serviced first if the minimal bandwidth of all queues is satisfied. The configuration of this command can only be attached to a physical port but not a port-channel. That is the minimum 197