D-Link DGS-1510 User Manual - Page 250

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide The dynamic fields that can be configured are described below: Parameter Source Destination Source Port Destination Port IP Precedence ToS DSCP Time Range Description Select and enter the source information here. Options to choose from are: • Any - Any source traffic will be evaluated according to the conditions of this rule. • Host - Enter the source host's IP address here. • IP - The Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are: • Any - Any destination traffic will be evaluated according to the conditions of this rule. • Host - Enter the destination host's IP address here. • IP - The Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the source port value here. Options to choose from are: • = - The specific selected port number will be used. • > - All ports greater than the selected port, will be used. • < - All ports smaller than the selected port, will be used. • ≠ - All ports, excluding the selected port, will be used. • Range - The start port number and end port number selected, of the range, will be used. Alternatively, the port number(s) can manually be entered in the space(s) provided, if the port number(s) is/are not available in the drop-down list. Select and enter the destination port value here. Options to choose from are: • = - The specific selected port number will be used. • > - All ports greater than the selected port, will be used. • < - All ports smaller than the selected port, will be used. • ≠ - All ports, excluding the selected port, will be used. • Range - The start port number and end port number selected, of the range, will be used. Alternatively, the port number(s) can manually be entered in the space(s) provided, if the port number(s) is/are not available in the drop-down list. Select the IP precedence value used here. Options to choose from are 0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flashoverride), 5 (critical), 6 (internet), and 7 (network). After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (maxthroughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. Select or enter the DSCP value used here. This value must be between 0 and 63. Enter the name of the time range to associate with this ACL rule. 239