D-Link DGS-1510 User Manual - Page 233
ACL Configuration Wizard Add Rule for IPv6 ACL Window, Destination
![]() |
View all D-Link DGS-1510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide Parameter Source Destination IP Precedence ToS DSCP Time Range Action Description Select and enter the source information here. Options to choose from are: • Any - Any source traffic will be evaluated according to the conditions of this rule. • Host - Enter the source host's IP address here. • IP - The Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are: • Any - Any destination traffic will be evaluated according to the conditions of this rule. • Host - Enter the destination host's IP address here. • IP - The Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select the IP precedence value used here. Options to choose from are 0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flashoverride), 5 (critical), 6 (internet), and 7 (network). After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (maxthroughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. Select or enter the DSCP value used here. This value must be between 0 and 63. Enter the name of the time range to associate with this ACL rule. Select the action that this rule will take here. Options to choose from are Permit and Deny. Click the Back button to return to the previous window. Click the Next button to continue. After clicking the IPv6 radio button and the Next button, the following window will appear. Figure 8-11 ACL Configuration Wizard (Add Rule for IPv6 ACL) Window This window has a dynamic section. Every selection made in the Protocol Type drop-down list will change the bottom part of this window. 222
![](/manual_guide/products/dlink-dgs1510-user-manual-acdf2fb/233.png)