D-Link DGS-1510 User Manual - Page 230

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide After selecting the ICMP option as the Protocol Type, the following section will appear. Figure 8-8 ACL Configuration Wizard (Add Rule for IPv4 ACL) ICMP Window The dynamic fields that can be configured are described below: Parameter Source Destination Specify ICMP Message Type ICMP Message Type Description Select and enter the source information here. Options to choose from are: • Any - Any source traffic will be evaluated according to the conditions of this rule. • Host - Enter the source host's IP address here. • IP - The Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are: • Any - Any destination traffic will be evaluated according to the conditions of this rule. • Host - Enter the destination host's IP address here. • IP - The Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select the ICMP message type used here. When the ICMP Message Type is not selected, enter the ICMP Message Type numerical value used here. When the ICMP Message Type is selected, this numerical value will automatically be entered. 219