Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 776

Other Settings SYSTEM SETTINGS Copy Exposure Adjustment This is used to adjust the exposure level when [Auto] is used for the copy exposure. Select separate settings for the document glass and for the automatic document feeder. Initial Margin Shift Setting This is used to set the default margin shift amount. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for both the front and reverse sides. Rotation Copy Setting When the original and paper are placed in different orientations, this function automatically rotates the image 90 degrees to enable correct copying on the paper. • Image rotation can only take place when automatic paper selection or automatic ratio selection is enabled. • The Rotation Copy setting must be enabled when copying an 5-1/2" x 8-1/2" (A5) size original on 5-1/2" x 8-1/2"R (A5R) paper. Add or Change Extra Preset Ratios Two enlargement preset ratios (101% to 400%) and two reduction preset ratios (25% to 99%) can be added. An added preset ratio can also be changed. Preset ratios other than added preset ratios cannot be changed. Setting a Maximum Number of Copies This is used to set the maximum number that can be entered for the number of copies (number of continuous copies). Any number from 1 to 999 can be specified. Erase Width Adjustment This is used to set the default erase width for erase copy. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for both edge erase and center erase. Card Shot Settings This is used to set the default original size for the card shot function. Both the X (horizontal) and Y (vertical) dimensions of the original can be set from 1" (25 mm) to 8-1/2" (210 mm) in increments of 1/8" (1 mm). Fit to Page Enable this setting to have the [Fit to Page] key always appear in the card shot screen. Automatic Saddle Stitch (When a saddle stitch finisher is installed.) This is used to have saddle stitch stapling take place automatically when the pamphlet copy function is used. Initial Tab Copy Setting This is used to set the default image shift width (tab width) for tab copying. The default width can be set from 0" (0 mm) to 5/8" (20 mm) in increments of 1/8" (1 mm). 7-74 Contents