Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 814

SYSTEM SETTINGS Fax Send Settings Settings for fax transmission can be configured. Auto Reduction Sending Setting This setting is used to have the size of transmitted faxes automatically reduced to match the size of the paper in the receiving machine. If the setting is disabled, faxes are sent at full size. Because the size is not adjusted to match the size of the printing paper, part of the received fax may be cut off. Rotation Sending Setting When transmitting an image that is one of the following sizes, this function rotates the image counterclockwise 90 degrees. (The setting can be configured separately for each size.) 8-1/2" x 11", 5-1/2" x 8-1/2"R, A4, B5R, A5R, 16K 8-1/2" x 11"R and A4R originals are not rotated. Quick On Line Sending When this setting is enabled, the machine starts transmitting a fax as soon as the first page is scanned. Transmission takes place at the same time as the remaining pages are being scanned. If you disable this setting, transmission will not begin until all pages have been scanned. Note that this setting does not apply to manual transmission. Printing Page Number at Receiver This setting is used to add the page number to the top of each fax page printed by the receiving machine. Date/Own Number Print Position Setting This setting determines the position of the date and sender information printed at the top of faxes by the receiving machine. To have the information printed outside the transmitted document image, touch the [Outside the Original Image] key. To have the information printed inside the document image, touch [Inside the Original Image] key. For more information on the print position, see "ADDING YOUR SENDER INFORMATION TO FAXES (Own number sending)" (page 4-98) in "4. FACSIMILE". Recall in Case of Line Busy This program is used to set the number of recall attempts and the interval between recall attempts when a transmission is not successful due to the line being busy or other reason. Number of Times to Recall When Line is Busy This setting specifies whether or not recalling is performed when the line is busy. When recalling is performed, you can set the number of recall attempts. Any number from 1 to 14 can be selected. Interval to Wait Between Recall Attempts (min.) When Line is Busy The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected. Even when this setting is enabled, note that your machine will not re-attempt a call when manual transmission or direct transmission is used. Recall in Case of Communication Error This determines how many times your machine will automatically re-attempt the call if a fax transmission fails due to a communication error. Number of Times to Recall in Case of Error Specify how many times the machine will re-attempt the call when a communication error occurs. Interval to Wait Between Recall Attempts (min.) in Case of Error The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected. Even when this setting is enabled, note that your machine will not re-attempt a call when manual transmission or direct transmission is used. 7-112 Contents