D-Link 3312SR Reference Manual - Page 107

DGS-3312SR Layer 3 Gigabit Switch config mirror delete mirrored. That is, the range of ports in which all traffic will be copied and sent to the Target port. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. rx − Allows the mirroring of only packets received by (flowing into) the port or ports in the port list. tx − Allows the mirroring of only packets sent to (flowing out of) the port or ports in the port list. both − Mirrors all the packets received or sent by the port or ports in the port list. Restrictions Only administrator-level users can issue this command. Example usage: To delete the mirroring ports: DGS-3312SR:4#config mirror port 1:5 delete source port 1:1-1:5 both Command: config mirror 1:5 delete source 1:1-1:5 both Success. DGS-3312SR:4# enable mirror Purpose Syntax Description Parameters Restrictions Used to enable a previously entered port mirroring configuration. enable mirror This command, combined with the disable mirror command below, allows you to enter a port mirroring configuration into the switch, and then turn the port mirroring on and off without having to modify the port mirroring configuration. None. Only administrator-level users can issue this command. Example usage: To enable mirroring configurations: 101