Home » D-Link Manuals » Hubs & Switches » D-Link 3312SR » Manual Viewer

D-Link 3312SR Reference Manual - Page 22

show config, enable telnet 23

UPC - 790069263873

Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

show config Purpose Syntax Description Parameters Restrictions DGS-3312SR Layer 3 Gigabit Switch Used to display the configuration of the switch. show config [current_config | config_in_NVRAM] This command displays either the current configuration of the switch, or the configuration stored in the switch's NVRAM. current_config − displays the switch's current configuration. If you have entered a configuration command, but have not saved the configuration in the switch's Non-Volatile RAM (NVRAM), this configuration will differ from the one saved in the switch's NVRAM. config_in_NVRAM − displays the switch's configuration saved in the switch's NVRAM. Any configuration commands that have been entered, but not saved in the switch's NVRAM will not be shown. Only Administrator-level users can issue this command. Example usage: To display the switch's configuration information: DGS-3312SR:4#show config current_config Command: show current_config # BASIC config serial_port baud_rate 9600 auto_logout 10_minutes enable telnet 23 enable web 80 # STORM config traffic control 15:1-15:2 broadcast disable multicast disable dlf disable threshold 128 # GM config sim candidate disable sim config sim dp_interval 30 config sim hold_time 100 # SYSLOG disable syslog #QOS config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config scheduling_mechanism round_robin config 802.1p user_priority 0 2 16

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296