Home » D-Link Manuals » Hubs & Switches » D-Link 3312SR » Manual Viewer

D-Link 3312SR Reference Manual - Page 260

config pim, enable pim, DGS-3312SR:4#enable pim

UPC - 790069263873

Add to My Manuals
Save this manual to your list of manuals

Page 260 highlights

DGS-3312SR Layer 3 Gigabit Switch config pim Restrictions state [enable | disable] - This can enable or disable PIM for the specified IP interface. The default is disabled. Note that PIM settings must also be enabled globally for the switch with the enable pim described below for PIM to operate on any configured IP interfaces. Only administrator-level users can issue this command. Usage Example: To configure PIM settings for IP interface "System": DGS-3312SR:4#config pim ipif System hello 35 jp_interval 70 state enable Command: config pim ipif System hello 35 jp_interval 70 state enable Success. DGS-3312SR:4# enable pim Purpose Syntax Description Parameters Restrictions Used to enable PIM function on the switch. enable pim This command will enable PIM for the switch. PIM settings must first be configured for specific IP interfaces using the config pim command. None. Only administrator-level users can use this command. Usage Example: To enable PIM as previously configured on the switch: DGS-3312SR:4#enable pim Command: enable pim Success. DGS-3312SR:4# disable pim Purpose Syntax Used to disable PIM function on the switch. disable pim 254

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296