D-Link 3312SR Reference Manual - Page 231
config vrrp ipif authtype, config vrrp ipif authtype <ipif_name 12> [none | simple authdata
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
DGS-3312SR Layer 3 Gigabit Switch config vrrp ipif authtype Purpose Syntax Description Parameters Restrictions To configure the authentication type for a VRRP entry. config vrrp ipif authtype [none | simple authdata | ip authdata ] This command is used to set the authentication type for a VRRP entry on the switch. - Enter the name of a previously configured IP interface that you wish to configure the VRRP entry for. This IP interface must be assigned to a VLAN on the switch. authtype - Specifies the type of authentication used. The authtype must be consistent with all routers participating within the VRRP group. The user may choose between: none - Entering this parameter indicates that VRRP protocol exchanges will not be authenticated. simple authdata - This parameter, along with an alphanumeric string of no more than eight characters, to set a simple password for comparing VRRP message packets received by a router. If the two passwords are not exactly the same, the packet will be dropped. ip authdata - This parameter will require the user to set an alphanumeric authentication string of no more than 16 characters to generate a MD5 message digest for authentication in comparing VRRP messages received by the router. If the two values are inconsistent, the packet will be dropped. Only administrator-level users can issue this command. Example usage: To set the authentication type for a VRRP entry: DGS-3312SR:4#config vrrp ipif Trinity authtype simple authdata tomato Command: config vrrp ipif Trinity authtype simple authdata tomato Success. DGS-3312SR:4# 225
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/231.png)