D-Link 3312SR Reference Manual - Page 117

DGS-3312SR Layer 3 Gigabit Switch 16 LINK AGGREGATION COMMANDS The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command Parameters create link_aggregation group_id {type [lacp | static]} delete link_aggregation group_id config link_aggregation group_id {master_port | ports state [enable | disable]} config link_aggregation [mac_source | mac_destination | mac_source_dest | ip_source | algorithm ip_destination | ip_source_dest] show link_aggregation {group_id | algorithm} config lacp_port mode [active | passive] show lacp_port {} Each command is listed, in detail, in the following sections. NOTE: As a stand-alone switch or as a master switch in a switch stack, the switch number will be referred to as 15 for all configurations, graphs and tables. create link_aggregation Purpose Syntax Description Parameters Restrictions Used to create a link aggregation group on the switch. create link_aggregation group_id {type [lacp | static]} This command will create a link aggregation group with a unique identifier. − Specifies the group ID. The switch allows up to 6 link aggregation groups to be configured. The group number identifies each of the groups. type - Specify the type of link aggregation used for the group. If the type is not specified the default type is static. lacp - This designates the port group as LACP compliant. LACP allows dynamic adjustment to the aggregated port group. LACP compliant ports may be further configured (see config lacp_ports). LACP compliant must be connected to LACP compliant devices. static - This designates the aggregated port group as static. Static port groups can not be changed as easily as LACP compliant port groups since both linked devices must be manually configured if the configuration of the trunked group is changed. If static link aggregation is used, be sure that both ends of the connection are properly configured and that all ports have the same speed/duplex settings. Only administrator-level users can issue this command. 111