D-Link 3312SR Reference Manual - Page 135

DGS-3312SR Layer 3 Gigabit Switch config router_ports Purpose Syntax Description Parameters Restrictions Used to configure ports as router ports. config router_ports [add | delete] This command allows you to designate a range of ports as being connected to multicast-enabled routers. This will ensure that all packets with such a router as its destination will reach the multicast-enabled router − regardless of protocol, etc. − The name of the VLAN on which the router port resides. [add | delete] - Specify if you wish to add or delete the following ports as router ports. − Specifies a range of ports that will be configured as router ports. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. Only administrator-level users can issue this command. Example usage: To set up static router ports: DGS-3312SR:4#config router_ports default add 2:1-2:10 Command: config router_ports default add 2:1-2:10 Success. DGS-3312SR:4# show router_ports Purpose Used to display the currently configured router ports on the switch. Syntax show router_ports {vlan } {static | dynamic} Description This command will display the router ports currently configured on the switch. Parameters − The name of the VLAN on which the router port resides. static − Displays router ports that have been statically configured. dynamic − Displays router ports that have been dynamically configured. Restrictions None. 129