Home » D-Link Manuals » Hubs & Switches » D-Link 3312SR » Manual Viewer

D-Link 3312SR Reference Manual - Page 227

disable vrrp, DGS-3312SR:4#enable vrrp

UPC - 790069263873

Add to My Manuals
Save this manual to your list of manuals

Page 227 highlights

Example Usage: DGS-3312SR Layer 3 Gigabit Switch To enable VRRP globally on the switch: DGS-3312SR:4#enable vrrp Command: enable vrrp Success. Example usage: DGS-3312SR:4# To enable the virtual IP address to be pinged: DGS-3312SR:4#enable vrrp ping Command: enable vrrp ping Success. DGS-3312SR:4# disable vrrp Purpose To disable a VRRP interface configuration. Syntax disable vrrp {ping} Description This command will disable the VRRP interface configuration on the switch. Parameters {ping} - Adding this parameter to the command will stop the virtual IP address from being pinged from other host end nodes to verify connectivity. This will only disable the ping connectivity check function. To disable the VRRP protocol on the switch, omit this parameter. Restrictions Only administrator-level users can issue this command. Example usage: To disable the VRRP function globally on the switch: DGS-3312SR:4#disable vrrp Command: disable vrrp Success. Example usage: DGS-3312SR:4# To disable the virtual IP address from being pinged: 221

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296