D-Link 3312SR Reference Manual - Page 125
config ipif, Command: create ipif p1 ipaddress 12.1.1.1 Trinity secondary state enable
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
DGS-3312SR Layer 3 Gigabit Switch DGS-3312SR:4# create ipif p1 ipaddress 10.1.1.1 Trinity state enable Command: create ipif p1 ipaddress 10.1.1.1 Trinity state enable Success. DGS-3312SR:4# To create the secondary IP interface, s1 on VLAN Trinity: DGS-3312SR:4#create ipif p1 ipaddress 12.1.1.1 Trinity secondary state enable Command: create ipif p1 ipaddress 12.1.1.1 Trinity secondary state enable Success. DGS-3312SR:4# config ipif Purpose Syntax Description Parameters Restrictions Used to configure the System IP interface. config ipif [{ipaddress | {vlan | state [enable | disable]} | bootp | dhcp] This command is used to configure the System IP interface on the switch. − The name for the IP interface previously created, that is to be configured. ipaddress − IP address and netmask of the IP interface to be configured. You can specify the address and mask information using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8). vlan − The name of the VLAN corresponding to the System IP interface. state [enable | disable] − Allows you to enable or disable the IP interface. bootp − Allows the selection of the BOOTP protocol for the assignment of an IP address to the switch's System IP interface. dhcp − Allows the selection of the DHCP protocol for the assignment of an IP address to the switch's System IP interface. Only administrator-level users can issue this command. Example usage: To configure the IP interface System: 119
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/125.png)