D-Link 3312SR Reference Manual - Page 284
create ospf virtual_link
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
DGS-3312SR Layer 3 Gigabit Switch Interface Name: ipif2 Network Medium Type: BROADCAST Area ID: 1.0.0.0 Priority: 1 DR Address: 123.234.12.34 Hello Interval: 10 Transmit Delay: 1 Authentication: None IP Address: 123.234.12.34/24 ((Link Up) Metric: 1 Administrative State: Enabled DR State: DR Backup DR Address: None Dead Interval: 40 Retransmit Time: 5 Total Entries: 2 DGS-3312SR:4# create ospf virtual_link Purpose Syntax Description Parameters Restrictions Used to create an OSPF virtual interface. create ospf virtual_link {hello_interval | dead_interval | authentication [none | simple | md5 ]} This command is used to create an OSPF virtual interface. − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain. − The OSPF router ID for the remote area. This is a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area's Area Border Router. The router ID of the neighbor router. hello_interval − Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. dead_interval − Allows the specification of the length of time between the receipt of Hello packets from a neighbor router before the selected area declares that router down. An interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly divisible by the Hello Interval. authentication - Enter the type of authentication preferred. The user may choose between: none - Choosing this parameter will require no authentication. simple − Choosing this parameter will set a simple authentication which includes a case-sensitive password of no more than 8 characters. md5 − Choosing this parameter will set authentication based on md5 encryption. A previously configured MD5 key ID (1 to 255) is required. Only administrator-level users can issue this command. Usage Example To create an OSPF virtual interface: 278
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/284.png)