D-Link 3312SR Reference Manual - Page 202

DGS-3312SR Layer 3 Gigabit Switch DGS-3312SR:4# config traffic_segmentation 1:1-1:9 forward_list 1:10-1:12 Command: config traffic_segmentation 1:1-1:9 forward_list 1:10-1:12 Note: If a port in forward_list belongs to a different slave form source_port, all ports on the slave will be added in forward_list. Success. DGS-3312SR:4# show traffic_segmentation Purpose Used to display the current traffic segmentation configuration on the switch. Syntax show traffic_segmentation Description The show traffic_segmentation command is used to display the current traffic segmentation configuration on the switch. Parameters − Specifies a range of ports for which the current traffic segmentation configuration on the switch will be displayed. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. Restrictions The port lists for segmentation and the forward list must be on the same switch. Example usage: To display the current traffic segmentation configuration on the switch. DGS-3312SR:4#show traffic_segmentation 1:1-1:12 Command: show traffic_segmentation 1:1-1:12 Traffic Segmentation Table Port Forward Portlist 1:1 1:1-1:12,2:1-2:12 1:2 1:1-1:12,2:1-2:12 1:3 1:1-1:12,2:1-2:12 1:4 1:1-1:12,2:1-2:12 1:5 1:1-1:12,2:1-2:12 1:6 1:1-1:12,2:1-2:12 1:7 1:1-1:12,2:1-2:12 1:8 1:1-1:12,2:1-2:12 1:9 1:1-1:12,2:1-2:12 1:10 1:1-1:12,2:1-2:12 1:11 1:1-1:12,2:1-2:12 1:12 1:1-1:12,2:1-2:12 DGS-3312SR:4# 196