D-Link 3312SR Reference Manual - Page 7
Introduction, Accessing the Switch via the Serial Port - dgs user manual
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
DGS-3312SR Layer 3 Gigabit Switch 1 INTRODUCTION The switch can be managed through the switch's serial port, Telnet, or the Web-based management agent. The Command Line Interface (CLI) can be used to configure and manage the switch via the serial port or Telnet interfaces. This manual provides a reference for all of the commands contained in the CLI. Configuration and management of the switch via the Web-based management agent is discussed in the User's Guide. Accessing the Switch via the Serial Port The switch's serial port's default settings are as follows: • 9600 baud • no parity • 8 data bits • 1 stop bit A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as above is then connected to the switch's serial port via an RS-232 DB-9 cable. With the serial port properly connected to a management computer, the following screen should be visible. If this screen does not appear, try pressing Ctrl+r to refresh the console screen. Figure 1-1. Initial CLI screen 1
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/7.png)