D-Link 3312SR Reference Manual - Page 186
config 802.1x auth_parameter, authentication attempt.
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
DGS-3312SR Layer 3 Gigabit Switch config 802.1x auth_parameter Parameters − Specifies a range of ports. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. all − Specifies all of the ports on the switch. default − Returns all of the ports in the specified range to their 802.1x default settings. direction [both | in] − Determines whether a controlled port blocks communication in both the receiving and transmitting directions, or just the receiving direction. port_control − Configures the administrative control over the authentication process for the range of ports. The user has the following authentication options: • force_auth − Forces the Authenticator for the port to become authorized. Network access is allowed. • auto − Allows the port's status to reflect the outcome of the authentication process. • force_unauth − Forces the Authenticator for the port to become unauthorized. Network access will be blocked. quiet_period − Configures the time interval between authentication failure and the start of a new authentication attempt. tx_period − Configures the time to wait for a response from a supplicant (user) to send EAP Request/Identity packets. supp_timeout − Configures the time to wait for a response from a supplicant (user) for all EAP packets, except for the Request/Identity packets. server_timeout − Configure the length of time to wait for a response from a RADIUS server. max_req − Configures the number of times to retry sending packets to a supplicant (user). reauth_period − Configures the time interval between successive re-authentications. enable_reauth [enable | disable] − Determines whether or not the switch will re-authenticate. Enabled causes re-authentication of users at the time interval specified in the Re-authentication Period field, above. Restrictions Only administrator-level users can issue this command. Example usage: To configure 802.1x authentication parameters for ports 1 - 20 of switch 1: 180
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/186.png)