Home » D-Link Manuals » Hubs & Switches » D-Link 3312SR » Manual Viewer

D-Link 3312SR Reference Manual - Page 77

config stp version, config stp, Example usage, To disable STP on the Switch

UPC - 790069263873

Add to My Manuals
Save this manual to your list of manuals

Page 77 highlights

Example usage: DGS-3312SR Layer 3 Gigabit Switch To disable STP on the Switch: DGS-3312SR:4#disable stp Command: disable stp Success. DGS-3312SR:4# config stp version Purpose Syntax Description Parameters Restrictions Used to globally set the version of STP on the Switch. config stp version [mstp | rstp | stp] This command allows the user to choose the version of the spanning tree to be implemented on the Switch. mstp - Selecting this parameter will set the Multiple Spanning Tree Protocol (MSTP) globally on the Switch. rstp - Selecting this parameter will set the Rapid Spanning Tree Protocol (RSTP) globally on the Switch. stp - Selecting this parameter will set the Spanning Tree Protocol (STP) globally on the Switch. Only administrator-level users can issue this command. Example usage: To set the Switch globally for the Multiple Spanning Tree Protocol (MSTP): DGS-3312SR:4#config stp version mstp Command: config stp version mstp Success. DGS-3312SR:4# config stp Purpose Syntax Description Parameters Used to setup STP, RSTP and MSTP on the Switch. config stp {maxage | maxhops | hellotime | forwarddelay | txholdcount | fbpdu [enable | disable]} This command is used to setup the Spanning Tree Protocol (STP) for the entire switch. All commands here will be implemented for the STP version that is currently set on the Switch. maxage − This value may be set to ensure that old information does not endlessly circulate through redundant paths 71

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296